V6 PUMPS
For Any Query Contact:
- +91 88800 08861
DELMA SERIES
150MM SUBMERSIBLE, 150MM STAINLESS STEEL DELMA SERIES
CRI 150 mm Borewell Submersible Pumpsets are powered by water filled, rewindable submersible motor suitable for continuous duty. The stator is wound with special water proof synthetic film insulated copper winding wires and made up of low watt loss silicon steel laminations assembled under pressure and rigidly locked in stainless steel stator shell.
T-Bolt design in all motor ensures rigid construction. Optimal design of impellers and diffusers offers best possible hydraulic efficiency. Built-in check valve prevents back flow and reduces the risk of water hammering.
- Optimized hydraulic design for efficient performance
- Specially designed thrust bearing to withstand high axial load
- T-Bolt design motor ensures rigid construction
- Smooth surface finish results friction free flow of fluid
- Designed for wide voltage applications
- SS 304 grade stainless steel stage casings and impellers in radial flow series
- SS 410 impeller/ bronze impeller available in mixed flow series
- Horizontal application model available
| Power Range | 1.5kW - 26kW (2HP - 35HP) |
| Voltage Range | Single Phase 200 - 240V, Three Phase 380 - 415V, 50 Hz, A.C. Supply |
| Maximum Total Head | 516 metre |
| Maximum Flow Rate | 22 lps ( 79.2 m3 /h ) |
| Casing | Cast Iron |
| Impeller | SS 304 & SS 410 |
| Pump Shaft | SS 410 / 431 |
| Upper and Lower Casing | Cast Iron |
| Shaft | SS 410 with EN-9 with 304 |
BINDA 6D SERIES
150MM SUBMERSIBLE, 150MM STAINLESS STEEL BINDA 6D SERIES
Motor: C.R.I. 150 mm Borewell submersible pump sets are powered by water filled, rewindable submersible motor which is suitable for continuous duty. The stator is wound with special waterproof synthetic film insulated copper winding wires and made up of low watt loss silicon steel laminations assembled under pressure and rigidly locked in stainless steel stator shell. T-Bolt design in all motors ensures rigid construction.
C.R.l.’s new double depth BINDA 6D+ 150 mm Borewell submersible pumps are specially designed for conditions where the ground water level is too deep. This series guarantees long life with energy-efficient performance. The built in check valve prevents back flow, and reduces the risk of water hammer.
- Double working capacity compared to other pump sets
- Corrosion resistant SS 304 stage casing SS 410 impeller increases the life of pump
- Helps to lift water from higher depth with reduced number of stages.
- Carbon Teflon pads are used to withstand the up thrust load.
- Specially designed Thrust Bearings to withstand high axial thrust loads
- High operating efficiency and consistent performance ensures low operation cost
- Motor is designed with higher cooling effect by increasing the housing areas.
| Power Range | 2.2 kW - 22 kW (3 HP - 25 HP) |
| Voltage Range | 3Ph - 380 - 415V, AC Supply |
| Maximum Total Head | 500 Metre |
| Maximum Flow Rate | 20 lps (72 m3/hr) |
| Part Name | Material |
|---|---|
| Suction Housing | Cast Iron with SS 410 Top Plate |
| Impeller | SS 410 |
| Pump Shaft | SS - 410 |
| Motor Base | Cast iron |
Applications
Ready to Enhance Your Plumbing and Farming Setup?
Connect with us today for high-quality products and expert advice. Whether it’s a large-scale project or a home renovation, we’ve got you covered.
- +91 88800 08861